- timing being pulled?
- SAFC wired to MAP+TIP?
- A piggy back that controls the injectors directly?
- problem
- Oil Pressure Question?
- SAFCII vs. E-Manage
- What SAFC to get????
- DTEC quit working
- 03/04 pcm swap
- Question on return kit
- problem with DTEC
- Easy DTEC?
- EGTs
- lambda
- AEM EMS Works with PT Cruiser.......
- help with DTEC Boost controller
- Whats the best wideband for beginners
- Clamp question
- AFR's at Boost Spike?
- Tunning safc?
- Wideband Tuner?
- Wideband 02
- Air/Fuel help
- safcII trouble
- super rich need some help
- loud pop
- FEELER: F/S Apexi AVC-R EBC
- Dtec manual
- TPS Voltage @ WOT?
- knock light question
- blitz turbo timmer
- safc help
- how do u get rid of code 0113
- tuning my mapclamp, fpr mod, and wga
- ? about fans
- EGT Probe Horror Stories? Let's hear em!
- Big Turbo problems
- need some help with code P0113
- FL tuners
- AEM UGEO install question
- Need some advice...
- wideband ??? NEED help
- HLFVIPR...Throwing misfire and rich/lean codes....WHY?
- Is my map clamped too much???
- Whats wrong w/my dyno?
- Macellaro's Performance Tuning at Car Show and Dyno on July 29, 2006
- Boost by gear & knock light instuctions...
- Will the 2-Step limiter come on during WOT Shifting?
- Need help diagnosing problem
- p0633
- knock count of 100+
- someone please help..
- AEM EMS Sale!
- Map Clamp vs SAFC on stage 0 with injectors
- Apexi SAFC I
- A/F Ratio
- Greddy E-manage help!!
- What do you know about a knock sensor?
- safc power wire question
- Long Term Fuel trim v. Short term - idealogy
- reading afr's on dtec fcbc
- Car's jacked up after mapclamp tuning...
- How about starting a TEC3R section?
- after my fpr install?
- Make a map clamp
- Need Help And Dont Know Where Else To Go!!!!!
- Really need help with my SAFC settings!
- wiring diagram for Apexi Neo
- afr ?
- possible SAFC problem
- need help asap car wont start after safc install
- CAI and Catch Can Install Issue...
- Wideband Sensor Calibration?
- pcm reflash question...
- greddy e01 problem
- weird afr's in close loop
- Cam Position Sensor Problem Need Help!!
- okay P0203 and stuck
- can i use SAFC and a Map clamp??
- bad turbo??? need help
- safc 2 vs emanage
- Stage 2 Fuel Pressure Release?????
- Help me safc II tuning gods.
- How to install narrowband
- I'm having big problems w/ my SRT-4
- Where to put AIT DTEC Sensor
- Mapclamp Causes Boost Loss????****
- Dtech Fuel Controller or SAFC2
- Opinions Needed!
- safc2 map
- 345hp on stg2 w/aem ems??
- Map clamp broke?? or is it my fault?
- about cutting through map sensor wires
- few questions about safc
- alright LM1 problem is good now but need to know something
- why is my LM1 reading 14.4 at idle for AFR
- Cant richen her
- need answers before i get tuned tomorrow
- L.A Tuners
- S2 injectors on S0 2005
- "knock retard" - definition? ideology?
- Using LM-1 to tune map clamp
- Help installing AIR/FUEL guage..please
- Total tuning newb need guidance
- Tuning/Dyno Event in Southern California
- compiling info, 6200rpm breakups on standalones
- what is needed for wideband O2
- which is easier to tune!???
- dual stage closed loop! all the time!
- safcii harness?
- problem with greddy profec spec 2
- Spark Advance is Low and Dyno Plot is very erradic
- safc install question
- Safcii Problem
- Car isn't running to hot
- Will this setup work?
- Need help understanding Our PCMs
- All E-01 peeps please check this out......
- About wideband routing
- Bc Or Mapclamp??
- aem uego
- map clamp help!!!!!!
- apexi neo safc
- How to read AFR
- Tuning questions
- Need Some Wideband Help!!
- tuning map clamp
- pulling -26% wot too much???
- Where did my timing go?
- AFR's dropping to low to fast! Help!
- How To: Wire you own Zeitronix plugs Save $50!!!
- safc help
- MAP clamp..SAFC???
- my car is f-ing slow
- Wideband Problem, help!
- Voltage VS. AFR Graphs **pics**
- Mapclamp: Cut wires or just tap into them??
- Starting point for tuning safc2
- Map Clamp
- Interesting observation
- SAFC 2 harness question.
- Fuel Pump Rewire : Cure for Dry Humps
- checking timing at WOT?
- anyone running DTEC FCBC on stock turbo/wg?
- info on original safc
- HELP with Map Clamp set-up
- Help Please
- map clamp
- Lm-1 install ?
- Need Help Setting Up Greddy E-01
- Need some help
- datalogger opinions
- Help! dtech question
- Help please!
- Laptop Mount
- EGT question-
- DTEC Map Sensor location
- Need an SAFC manual
- how much hp
- New to the Map Clamp
- reflash
- HELP need DTEC parts
- what does everyone like, safc vs dtec vs emanage vs ptp ftm vs everything else?
- Help with S1 and S0 problems!!!!!!!!!
- a/f ratios?
- SRT4 PCM question
- problems with aem wideband & greddy Turbo timer
- 11.8 a/f at redline?
- stage2 map sensor help
- questions about safc mounting
- Do I need a tach driver to use my APexi SAFC?
- map sensor wires
- trans code-state inspection
- aem uego
- Basic Tuning question
- So i added a 60mm t/b everything is knocked off the the dtec now?
- Dtec boost issues... need help
- igntion cut...Gurus need your help!!
- what a/f is safe?
- DTEC tuning noob question
- popcorn
- Tuning with SAFC-2 question.....
- I'm Out Of Ideas..Help
- DTEC load input and output
- Aem Wideband
- UEGO on the Fritz!!! Help Diagnose
- WANTED: GT3071R Dtec maps
- no idea whats wrong
- DTEC Reading 9000+ RPMS
- UEGO + Emanage assistance
- Hesitation low RPM ?
- newb on datalogging
- AFR Stock
- Need help from the smart SRT'ers! Sensor problem?
- RPM Problems SRT-4
- timing maps?
- installed my mapclamp today
- what interceptor recorded (ignition timing)
- 20+ A/F ratio & reving by itself
- DTEC Problems...Help please
- DTEC not reading RPM's properly
- Help with zeitronix data logger
- decode?
- dtec problems...
- hooking up a/f gauge to zeitronix can I do it
- Timing gauge
- Diary of a custom wideband (start to finish)
- 3 Bar Map Sensor on Stage 1
- Optimal wideband readings....
- s2 pulling time question!!!
- Egt
- Car faster with A/Fs in the 10s?
- PLX iMFD Gauges
- please help fuel/spark problems
- Stage 3 timing (right?)
- Apexi AFC nom
- Need advice on Tuning
- tuning woes
- Apexi V-AFC
- Tuning at 58PSI or Boost referenced 40PSI
- Car running like crap! help please..
- Knock and Tuning
- PCM Question
- tuning
- Big turbo + Scan Gauge or Tech gauge PLEASE read
- Input on new Apexi AFC NEO
- 50 trim, 22 psi, and HOM?? Bomb..or safe?
- s2 w/o toys DAS MAPCLAMP VOLTAGE
- datalogging a lc-1
- PLX Wideband (Any Vendors?)
- Advanced numbers-are these good?
- Upping the Boost
- Chart for map sensor voltage's
- e-01 help!
- Which PCM?
- wideband discussion
- stg 2 timing
- Tuning to start with
- Is there difference in 3rd gear pull and 4th gear pull
- data logging program
- safc2 setting for stage 2??
- emanage question (red light)
- AEM UEGO just installed...got some questions
- Help with SAFC
- what voltage to clamp s3r?
- Timing issues, Please help
- AFC question
- booost vs timing with some data
- wideband with E01
- Sorry to butt in but...