- e-Manage blinking and P0108
- MAP Clamp help needed....
- Tuning Air Fuel And Boost With Dtec
- P2302 P2305 Codes With MSD
- AEM EMS installed!!!
- Map Clamp Problem..Help
- pcm problem
- AEM EMS' are IN!!!!
- Car won't rev past 3800 rpm after safc install!!
- build your own Greddy support tool!!
- What do i need for tuning?
- stage0 owners with 750's
- Car Wont Start!!! I installed the Dtec FC and the tuner box
- base maps
- good air/fuel for my car?
- Greddy support tool Software???
- Dtec
- help with wideband readings...
- Please help stage 0 problem - Fuel cut with SAFC
- AEM EMS Certified Tuners in So Cali
- Help Need Cable!!!!
- Emanage maps
- MAP Voltage and Injector Pulse
- Reading map voltage...quick help please
- Dtec help please!!!!!!!!
- car has been acting very wierd please help
- GT35R turbo with mopar stage2 or stage0 and RC 750's
- tps/rpm avcr vs tps/rpm safc
- ecu reset switch
- Map Clamp Tuning Results
- A/F gauge help
- Apexi 2 tuning problems
- s2 w/ toys tunning question...
- Safc2 And Msd Question?
- a/f ratio in volts
- P 2074, and Idle problem!!
- air fuel ratio....ive already searched
- safc with 05
- Load based EBC, A cure for PTB.
- powerpaq removal
- Emanage & E01 combo
- Apexi AFC NEO???
- New To Tunning
- Aem Ems Just Released
- How can you pull to much vaccum? Also P0068!
- Map Clamp
- Help please...
- Plan to use a map clamp...how to go about really?
- what do you, use?
- tach adaper question
- tach adaper question
- In need of some Help guys
- psi-fi maps!?
- Xd-16?
- I would like opinions on my A/F readings
- Is this normal with clamped air fuel?
- Did some datalogging today and my Boost Gauge is reading Higher than the MAP Signal?
- Timing Getting Pulled?
- Anti-Lag/Misfiring system
- AEM Urego and E-01
- boost and fuel maps
- dumping fuel what do you think
- Got the D-Tec working with NGK AFx
- Timing / Fuel question
- DTEC FC/BC Install instructions
- How far is to far for wideband sensor?
- 50 trim owners
- UEGO readings on gt40
- Help!!!
- what are the symptoms of a bad o2 sensor? also still issues with the p0068!!!
- Use MAP signal instead of TPS on DTEC?
- i think there is something wrong with my AFR
- Wideband analog input to emanage?
- Stg 1 w/ Safc problem
- battery reset Vs afr's
- Trimming back fuel on SAFC/DTEC, cause PCM to boost more?
- Questions on EMS / Tec3r
- Newb tune question (clamp + extra fuel mods), car getting ready for bigger things...
- looking for dtec maps, for stock turbo
- life after hydra ems
- Data logging with AEM wideband
- Emanage map
- Zeitronix....
- GT3076R - Map Voltage - Regulator INFO
- Best Components for going Big Turbo
- DTECH FCBC vs. AEM EMS
- Safc vs mapclamp
- Checking Map Clamp Voltage via Boost Leak Tester
- SMT-6 / Power Pak tuning help.
- big turbo guys help please
- New Timing Numbers w/ Lucas Oil Octane Booster
- Power paq
- SAFC Tuning
- AFC just about tuned, but doesn't feel it
- AFC help
- Voltage at 22-23psi
- tuning W/I, nitrous
- DTEC problems...
- Question on tuning my setup
- signs of a bad MAP sensor?
- Local Vendor selling AEM EMS!
- TechGauges Timing/Knock results questions - 91 Octane, Stock '05
- Duty Cycle
- Does the 05 require a different set up for a Map Clamp to work?
- Best way to tune low throttle settings on Safc
- Re-wiring emanage to do rpm vs boost using e-01 3bar
- stage 2 fuel mapping!
- Need Dtec FCBC Install Instructions
- Emanage mounting location
- What current tuning systems can also control WI
- Some issues need resolved.... gt3076r
- DTEC FC HELP: Need base map for s2
- Another mapclamp question......
- After a tune on my AFC2 I got P0108....
- aem ems
- stock turbo tuning question(s)
- map clamp?again
- Unhooking battery ='s losing AFCII settings?
- Question about harness under center console.
- How many knock counts do you see with your DTEC?
- Help With Dtec
- ZT2 Pocketlogger help!!!!!!!!!!!!!!!!
- All CEL's are not created equal??- Help
- stage 1 + wga a/f ratio
- Aem Uego????
- Understanding the Function of SAFC question
- Fried the Pcm
- Dtec ???'s
- battery tender ok w/ electronics?
- Power Card Module question...
- Where should my timing/kr be with my mods?
- DTEC tps calibration ques?
- 3 bar?
- Apexi Turbo Timer A/F ? - Turning it into wideband
- Whats the best piggyback on the market?
- Running lean ???
- Zeitronix owners.................
- spark plug problem
- Quick Question on Tuning w/ Mapclamp and Wideband
- A/F's with a wideband
- Where is psi-fi power paq
- question about tuning programs
- Where are you mounting your boost solenoid for DTEC?
- tuning question
- DTEC Power Gain
- Stage 2 Jet Chips!
- Program stock ECM?
- anybody try this?????
- Dtec Without Large Turbo
- AEM EMS PnP for the SRT-4 in finally here
- Need help. two wires came out of DTEC where do they go?
- SAFC2 lost settings?
- e-manage ultimate?????????
- Knock retard for no apparent reasons...causes?
- Removed s2 inj and re-installed s1
- read my plugs please
- WIDEBAND question??
- Stage 2 advantage
- Interest in Knock retard/Timing/MAP voltage Guage
- Need DTEC fc help asap...getting constant 5.00mv even at idle
- Help!!!!
- Datalogger??
- DO these spark plugs look bad
- Help with fuel upgrade
- Does anyone have this product and how is it.
- Need a base map please
- mapclamp or safc?
- Wideband Selction Help
- 5o trim on stage two ecm
- SAFC II questions
- stage 2 afr question
- knock light?!!
- SAFC II settings
- Map clamp?
- Question about proper a/f at idle?
- my s0 timing with my set up
- Urgent, Immediate Attendance
- New E-Manage Ultimate...
- tuning help
- Tune Map Clamp?
- safc 2 discussion
- Timing, AFR, knock retard info from my car
- What Would You Do?
- anyone have the turbo xs tuner box instructions?
- dynojet wideband comander
- dyno the car not sure if i should be happy
- Powerpaq Software CD ?
- mapclamp install question
- tuning problems
- msd tach-driver question
- safc settings
- quick question
- Explanation of fuel trims HERE!
- obd2 scanner for laptop
- EGT gauge vs A/F guage
- Optima R Performance module?
- Looking for turbo xs tuner box instructions!
- datalogging with chrysler's drbIII
- Vafc
- Mapclamp?
- WTF is with my a/f ratio???
- is my A/F ratio normal for my setup????
- Anybody seen/use this fuel controller
- question about map sensor?
- need help fast
- SplitSecond
- ATTN: SAFC II users
- stage 0 a/f's inconsistent - Map clamp used 4 tuning
- knock reading (SAFC-II)
- Question about partial throttle tuning.
- New Name to keep the confusion down
- MAP & MAS voltage
- Stupid SAFC II Question....
- Smt-6 Help!!!!
- 3 bar map sensor
- dtec map sensor
- When installing SAFC...
- need emanage cd and e-01 cd instructions.
- help w/install of a/f gauge
- Stand alone question dealing with pump gas.
- Which OBD scanner for S3?
- Standalone options??
- Yeah the new crank trigger works with the Autronics
- Help ASAP - AFC Install
- need SAFC2 Lo settings for s1 w/ s2 injectors
- Question about EMS wiring ( tec3r etc)
- e-manage/e-01 problem
- Innovative wideband
- big turbo guys help please! - Fouling plugs, AFC too rich?
- map clamp "issues"
- Running Lean at low boost
- Zeitronix install
- AGP srt specific? SAFC II
- My A/F, what do you think
- Need Help Tunning
- innovate XD-1 & LC-1 installation questions
- eman/e-01. need maps on stock srt4.
- timing on big turbo cars
- safc settings help
- DTEC Base Map
- wideband/mapclamp help
- Stage 2 PCM Stock 577cc Injectors
- New FPR and SAFC II
- Flight Systems
- TechGauges...timing
- Which Wideband....
- where to place the DTEC-Tuner Box
- Dtec and zeitronix
- Autometer D-PIC
- Knock, Pulse-width, timing, etc... gauges