- UEGO Controller by AEM
- Do I Need To Tune?
- Spark and Timing Myths debunked
- to anyone using the rpm converter with the lm-1
- PDA Diagnostics
- EBC Vac line question
- Apexi AVC-R Throttle voltage fluctuating.
- WOT TPS voltage
- Is MSD tach Driver needed for s-afc2
- ** GREDDY e-01 TROUBLESHOOTING**
- Boost Cooler Water Inj on Two Guys Garage!
- S-Afc settings w/ my mods
- GReddy E-manage/E-01..need help.
- Stage 3 timing results/observations
- At a loss, 750cc+walbro255+60-1=lean at 12 psi
- What a/f ratio to tune for with S2+big turbo???
- Hey dataloggers!!! Toys fuel adjustments?
- Greddy E-Manage
- Accel Gen7
- tuning AFC2 with big turbo
- zeitronix screen shot and i need help with rpm signal
- LM-1,PC, and EMANAGE
- anybody with 50 trim help..
- just put the safc on last night
- How to lower timing??
- greddy profec b-spec 2
- have greddy E-01 boost control
- 400+hp which plugs?
- standalone
- wideband and e-01 conversion problem
- Datalogging to EO-1
- Car is not responding mods....added emanage too with dyno info
- MP S3R fuel pressure
- Stage 2 & SMT6 Analog fuel limits
- Stage & SMT6 or Power Paq Map voltage
- Stage 2 timing with HOM and tolulene
- Can I use the map lamp with the safc II
- lm-1 connected to e-01
- E-manage error code..... Help please!!!!
- O2 sensor readings?
- Need ideas for mounting EGT probe
- Tuning with s-afc2 and stage 2 injectors
- What would the RC 650cc injector be at 58psi..
- Is there A replacement
- Greddy E-Manage how much gain?
- Reading the Datalog.. SAFC w Throttle=Map
- could you run 750cc injectors with S2
- ok wtf, emanage users help
- HELP with fuel or timing problem
- Reflashing the ECU on an '04
- SAFC help PLEASE!!!!
- PLX M-300 Question
- E-01/Emanage and water injection
- EGT probe install
- All owners should voice their opinions..
- MSD Knock Alert
- I've heard GM makes a 3.0 Bar MAP Sensor.....
- Reason for 3 bar TIP sensor?
- most useful gauges?
- AEM 1050U or TEC3 will not work
- cant decide on a datalogger
- SRT wiring schematic
- P-n-P EMS for the SRT-4 *PICS*
- S-SAFC 2 + map clamp question
- ?'s on edtip mod
- Zeitronix + E-01 = ? settings
- said goodbye to my warrenty yesterday!!
- Need A Lot of Help!!
- where to install egt?
- 28 degrees timing advance! stock turbo, stock intercooler, no piggy backs
- Help me decide which wide band
- So who here has the timing tables for the srt-4
- MSD DIS-4 Ignition
- what kinda place tests injectors?
- Cool E-01 / E-manage feature *PIC*
- Rev limiter and top speed
- safc2
- pcm change
- just installed plx m-300...have a few questions
- Who makes the Best Wide Band air/fuel sensor/gauge?
- Dynojet Wideband Commander
- question dealing with dasmopar map clamp
- Tune the Stock Computer
- big turbo tuning help
- safc2 & return fuel questions and help!
- safc help
- Calculating AFR without the E-01 on the Emanage
- Super AFC II?????????
- 04 s0 + SAFC
- efficiency on stock bov.......
- advantages of powerpaq ontop of stage2
- stage 1 overboost.
- wideband question
- Help needed!!
- Emanage install...good idea
- Emanage or SAFCII
- Cold side pipe size in MM? 70mm?
- updating e-01
- Emanage w/ 3 bar sensor?
- what o2 sencer can I us that doesn't cost over 100 bills for a/f gauge
- Need a E-01 manual
- Autotap logger!
- Emanage add injector map?
- Mr Dyno - dyno graph
- PSI FI Powepack - Stage 2 setup
- Capping solenoids and replacing O2 sensor with wideband
- Code 107 Map Input Low
- Just a question regarding fuel
- Anyone tried a venom vcn 400?
- E-01 in winter!!
- MrDyno! (Gtech-ish thing) comparison tonight...
- vaccum digram
- e-01 forgetting settings
- PCM adapter
- Powerpaq and AEM EUGO
- S0 PCM S1 Injectors w/SAFCII??
- emanage user ?
- emanage w/ water injection
- How many are reliably using S-AFC2?
- Powerpaq map needed asap
- Buy Just Head Unit
- Buy Just Head Unit
- Questions About Options...
- wires!
- 4th gear cut out
- Definite voltage ranges For Sensors
- plx 300 wideband question
- E-Manage over AFC II???
- Anybody using the Zeitronix Wideband?
- Air Inlet Temps on different ICs
- schematic help
- E-manage and 02 sensor
- Do we need a harness to hook up wideband to E-01?
- TPS max percentage load 74.6%?
- Datalogging System for Laptop
- Emanage AFR/EGT
- Which gear do we use on the dyno?? 3rd or 4th??
- how do i know if my car is pulling timing on the top end?...
- stock pump vs stage 3 pump vs other pump vs walbro 255
- APEX-i AVC-R
- Emanage harness question?
- effects of leaded fuel
- Tuning advice: safc vs. emanage/powerpaq
- what tells the DME (pcm) what gear the trans is in for montioring boost?
- Weird Scenario...Car "Bogs" in 4th
- has anyone tried using a motec ECU?
- Max 4.00 Volts on my MAP!? WTF
- EBC or MBC?!?!
- safc on a 04 srt ? help
- rapid ticking
- what is a good f2a ratio
- HAving a Wierd Problem
- Adjusting the MAP clamp
- emanage or power paq?
- Where did you place your wideband O2 bung?
- E-01/Emanage ?
- SAFC2 Knock meter ??
- Getting engine Detonation
- Map sensor
- MAP Clamp Voltage???
- anyone used apex power fc?
- ignition timing differances between Stage 1 and Stage 0
- NE1 using just the EO-1 for boost controll?
- What is the PowerPaq??
- E-01, Eman, and Viper 791xv installed
- e-manage users, how to find out what firmware you are running??
- E-01 Displays A/F right?
- where can i find 950-1000cc injectors
- propper way to hook up aeromotive a1000 fuel pump
- Fuel system questions
- Need help deciding which is better for me.
- emanage w/return fuel line questions
- safc2 help!!!
- is the e manage from exhaust depot worth it?
- what is everyone using to datalog through the diagnostic port
- e-01 not reading rpm signal
- knock sensor
- E-01 settings?
- PowerPaq and Stage 2
- Best clamping volt for an 04 Stage 0 pcm with Fuel system?
- Expected performance?
- powerpaq on stage no toys
- Questions RE Emanage
- PLEASE HELP with E-01
- Ebc
- Getting the PLX wideband to log on the E-01
- internal damange ?
- PLX wideband sensor
- A/F targets at certain rpms.....
- e-manage not communicating with laptop?
- Setting up the E-01 to work with an external wastegate
- !! need help with greddy e-01!!!
- E-manage boost cut limiter question?
- 750cc injectors, E-manage, and no return line. How do I get it to idle...?
- ECU pin out
- s2 w/toys and emanage question
- what are the common HP and TQ results of eman and E-01?
- Greddy E-Manage -> Serial #?
- Datalogging?
- Need Some ECM/connector Pics
- P0108... All help and Opinions are APPRECIATED!!! please read!!!
- throwing 02 sensor codes and e01 won't turn on
- ???fuel pressure sensor on e-01
- !need Info Please, SAFC tuning help
- Emanage coming, tell me if i can do what i want
- Info on wideband devices
- Display timing on e-o1?
- AEM uego A/F voltage for data log on E-01
- SAFC newb ?
- Explain what S-AFC does with big turbo/big injectors (please) ??
- installing e-manage and e-01?
- E-manage Throttle input values..
- any reason not to do a S0 with the E-01 adn Eman rather then the S1?
- Need help/have a ques. on the SAFCII...
- Stock/autometer gauge ?'s
- Ignition coil ?'s
- Powerpaq install...
- AEM Uego w/ E-01 problem
- Any PLX wideband users ?
- powerpaq help
- Knock sensor
- Question on greddy boost controllers for ya!!
- powerpaq quesion
- Data Loggers
- Timing pulled
- Wot A/r
- High Octane Button Question
- e01 peeps what is your gain set at
- would switching ot an E-01, and an emanage help any
- code p0108
- How to preset a map clamp
- Need profec b spec 2 help!!!!
- Purchased MSD Ignition equipment, questions!
- what happens during fuel/timing cut?
- Map clamp w/SAFC question??
- Emanage/EO1 Wire Run Pics?
- p0203 & p0204 codes after Emanage install??
- MBC help.
- help me rid of fuel cut!!!
- Question on the PowerPaq (I read the sticky)
- Can I replace the stock o2 downstream sensor with my wideband one and ziptie stocker?
- How to turn on fans with 180 stat?
- EManage or psi-fi powerpaq.....that is the question
- Higher Revs Please
- Ignition timing questions (and nitrous too)
- Is this a good deal for used emange?
- Does anyone have the profec b II wiring diagram?
- Turboxcfuel cut defencer or map clamp and wideband?
- Emanage now commun. with E-01 and error on emanage Help...
- Profec B Spec II & E-01 Boost Solenoids the same??